Konica Minolta bizhub C3850FS bizhub C3850FS/C3850/C3350 Applied Functions Use - Page 83
Select [Enable] to use POP Before SMTP., Configuring the Scan to E-mail operating environment
View all Konica Minolta bizhub C3850FS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
2.1 Configuring the Scan to E-mail operating environment 2 2 In the administrator mode, select [Network] - [E-mail Settings] - [E-mail RX (POP)], then configure the following settings. Settings [E-mail RX (POP)] [POP Server Address] [Port Number] [Login Name] [Password] [Connection Timeout] Description Select [Enable] to use POP Before SMTP. [Enable] is specified by default. Enter the address of your E-mail server (POP). Use one of the following formats. • Example of host name entry: "host.example.com" • Example of IP address (IPv4) entry: "192.168.1.1" • Example of IP address (IPv6) entry: "fe80::220:6bff:fe10:2f16" If necessary, change the port number of the E-mail server (POP). Normally, you can use the original port number. [110] is specified by default. Enter the login name when E-mails are received using the E-mail server (POP) (using ASCII characters of up to 63 bytes). Enter the password (using ASCII characters of up to 15 bytes). To enter (change) the password, select the [Change Password] check box, then enter a new password. Change the time-out time to communicate with the E-mail server (POP), if necessary. [60 sec.] is specified by default. 3 Set the POP over SSL and APOP settings according to your environment. In the administrator mode, select [Network] - [E-mail Settings] - [E-mail RX (POP)], then configure the following settings. Settings [SSL/TLS] [Port Number (SSL)] [APOP Authentication] Description When using SSL to encrypt a communication with the E-mail server (POP), select [Enable]. [Disable] is specified by default. If necessary, change the SSL communication port number. Normally, you can use the original port number. [995] is specified by default. If you use APOP in your E-mail server (POP), select [Enable]. [Disable] is specified by default. [Applied Functions] 2-5