Kyocera ECOSYS P8060cdn Data Security Kit E Operation Guide Rev-2016.1 - Page 14

Warning Message If the encryption code information of the machine has been lost for some reason, the screen shown here appears when the power is turned on. Follow the steps below. Enter the encryption code. 1 Select [Encryption Code], and enter the encryption code that was entered during the installation of the security kit. Encryption Code Once Overwrite OK 10/10/2015 a1v002:0110 CAUTION: Even though entering a different encryption code can also enable continuation of a job, this will overwrite all the data stored in the hard disk/ SSD. Exercise extreme caution when entering an encryption code. The encryption code is not the same as the security password. 2 Turn the power switch off and on. Disposal If the machine is unused and demolished, perform Data Sanitization to erase the hard disk/SSD data. Refer to "Data Sanitization" of "Data Security" in Chapter 8 of the machine's Operation Guide. If the machine is unused and demolished, obtain directions for disposal from the dealer (from which you purchased the machine) or your service representative. 13