Kyocera FS-C5300DN FS-C5100DN/C5200DN/C5300DN Operation Guide Rev-1.2 (BASIC) - Page 58
General Guidelines, Tips, Symptom, Check Items, Corrective Action - troubleshoot
UPC - 632983010303
View all Kyocera FS-C5300DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
General Guidelines The table below provides basic solutions for problems you may encounter with the printer. We suggest you consult this table to troubleshoot the problems before calling for service. Symptom Check Items Corrective Action Print quality is not good. Refer to Print Quality Problems on page 4-3. Paper is jammed. Refer to Clearing Paper Jams on page 4-12. Nothing lights on the operation panel Check that the power cord is properly Turn off the printer's power, plug in the even when power is turned on and the plugged into the power outlet. power cord securely, and try turning on fan makes no noise. the printer's power again. Check that the power switch is in the Set the power switch to the On On (|) position. position. The printer prints a status page, but Check the printer cable or the interface Connect both ends of the printer cable does not print jobs from the computer. cable. securely. Try replacing the printer cable or the interface cable. Check program files and application software. Try printing another file or using another print command. If the problem occurs only with a specific file or application, check the printer driver settings for that application. The printer is emitting steam in the area around the top tray. Check the room temperature to see if it Depending on the printing environment is low, or if damp paper was used. and the paper's condition, the heat generated during printing will cause the moisture in the paper to evaporate, and the steam emitted may look like smoke. This is not a problem, and you can continue printing. If the steam concerns you, raise the room temperature, or replace the paper with a newer, dryer paper. Tips Printer problems may be solved easily by following the tips below. When you have encountered a problem that following the above guidelines will not solve, try the following: • Turn the printer power off and wait for several seconds. Then, turn on the printer. • Reboot the computer which sends the print jobs to the printer. • Obtain and use the latest version of the printer driver. The latest versions of printer drivers and utilities are available at: http://www.kyoceramita.com/download/. • Make sure that the procedures for printing are correctly followed in the application software. Consult the documentation supplied with the application software. 4-2 Troubleshooting