Kyocera KM-2030 Print System K Instruction Handbook (Setup) - Page 17
Error code, ppm copier, Display message, copier, Procedure - service mode
View all Kyocera KM-2030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
3. Troubleshooting Error code (15 ppm copier) Display message (20 ppm copier) - No duplex from bypass - Not from bypass to finisher E23 Paper capacity exceeded. Remve paper from Job sep. PAPER CAPACITY EXCEEDED. REMOVE PAPER FROM JOB SEP. E30 - E40 This code is not in use. Job is cancelled. - Exceeded print quantity limit. Exceeded pre-registered printing quantity. E60 RAM disk error Press GO E70 MemoryCard err Press GO E71 Memory Card err Insert again E72 Insert the same memory card E73 Format error Memory card Procedure Duplex printing is not possible using the Multi-Bypass. Select the drawer for paper feed. * If you want to print out on only one side of the paper, first press the Printer key to switch to the printer mode. Next, select the "GO" command and then press the Enter key. If you want to switch to and print from a cassette, press the Paper Select key until the desired cassette is selected and then press the Enter key. The finisher cannot be used when paper is fed from the Multi-Bypass. * If you want to have the paper ejected into the Inner tray, first press the Printer key to switch to the printer mode. Next, select the "GO" command and then press the Enter key. If you want to switch to and print from a cassette, press the Paper Select key until the desired cassette is selected and then press the Enter key. The amount of paper stacked in the optional Job Separator has exceeded the acceptable capacity. Remove all paper from the Job Separator. Trouble has occurred within the printer. Contact your service representative or an authorized service center. The department code you entered does not match the registered one. Check the department code that is registered in the printer driver. The amount of printing accomplished has exceeded the acceptable capacity as set under copy management. In order to print further, change the copy management setting in the printer. A read- or write-error has occurred on the RAM disk. Press the Start key. A read- or write-error has occurred on the RAM disk. First press the Printer key to switch to the printer mode. Next, select the "GO" command and then press the Enter key. A read- or write-error has occurred in the Memory Card (CompactFlash). Press the Start key. A read- or write-error has occurred in the Memory Card (CompactFlash). First press the Printer key to switch to the printer mode. Next, select the "GO" command and then press the Enter key. The Memory Card (CompactFlash) was removed during operation under the menu for printer-related settings. Reinsert the Memory Card. The Memory Card (CompactFlash) could not be detected during an operation in which the printer was reading data from that card. Reinsert the Memory Card. Initialization of the Memory Card (CompactFlash) currently inserted is necessary. 11