Kyocera KM-2560 2560/3060 Operation Guide (Basic Edition) - Page 47
Setting TCP/IP (When Using DHCP), Power, System Menu
View all Kyocera KM-2560 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Preparation before Use 6 Press [Subnet Mask] and enter the address using the numeric keys. 7 Press [Default Gateway] and enter the address using the numeric keys. 8 Check that all addresses are entered correctly, and press [OK]. 2 9 Press the Power key, and after confirming that the Power key/indicator and memory indicator have turned off, turn the main power switch off and on. Setting TCP/IP (When Using DHCP) Follow the steps below to set TCP/IP when a DHCP server is available. 1 Press the System Menu key. 2 Press [System], [Next] of Network and then [Change] of TCP/IP. 3 Press [On] of TCP/ IP and [On] of DHCP. System - TCP/IP Use TCP/IP. DHCP Off On On Off Status 4 Press [OK]. IP Address Subnet Mask Default Gateway 0.0 .0 .0 0.0 .0 .0 0.0 .0 .0 Cancel OK 10/10/2007 10:10 5 Press the Power key, and after confirming that the Power key/indicator and memory indicator have turned off, turn the main power switch off and on. OPERATION GUIDE 2-11