Kyocera TASKalfa 180 180/220 Operation Guide Rev-2 - Page 129
Start, Logout, Display, Corrective Procedure, Reference, Return all
View all Kyocera TASKalfa 180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Troubleshooting Display Replace waste toner box. Corrective Procedure Reference Page The waste toner box is full. Replace it with a new waste 7-9 toner box. Remove paper on top tray; Start. 250 copies have been stored on output tray. Remove - the paper, press the Start key and resume copying. Reseat originals on DP. Originals were set in the optional Document Processor - when copying on 2-sides (front and back sides), when copying from the platen in 2-Sided copy, 2 in 1, 4 in 1 or when collating copies. Remove the originals from the Document Processor, replace the originals on the Original Table after exiting the front and back copying, 2Sided copy, 2 in 1, 4 in 1 or Collate Mode and resume copying. Return all originals to DP. If the optional Document Processor is being used, there - are originals left on the original table. Remove the originals, return them to the original table and try copying them again. Set paper cassette. Check the paper cassette that corresponds to the 2-4 lighting indicator. Set the cassette. 8 Shake the toner container. Tap and shake the new toner container without spilling 7-9 the toner, and install it again. Set toner container. The Toner Container has not been set. Set the Toner 7-9 Container. The Add Toner indicator blinks on There is very little toner remaining. Copying can be 7-9 and off. continued for a short while before running out of toner. Prepare the toner container. The Periodic Maintenance This is a notification that the time for periodic - indicator blinks on and off. maintenance is approaching. The Periodic Maintenance indicator lights up. It is time for Periodic Maintenance. Contact your service - representative. "= = =" appears on the copy quantity display. Job Accounting being set. Use the numeric keys to enter 6-9 the assigned Section Code to perform copying operations. Press the Logout key after copying is finished to display "= = =" again. OPERATION GUIDE 8-7