Kyocera TASKalfa 180 Operation Guide - Page 79

Troubleshooting Responding to Error Messages If the touch panel displays any of these messages, follow the corresponding procedure. Alphanumeric Display Add paper in cassette #. Corrective Procedure There is no paper in the cassette. Load paper into the cassette as displayed in place of #. Add toner. Copies cannot be produced because there is no toner. Replace the toner container with a new one. Cannot copy this orig. size. Cannot duplex this paper size Call service. C#### Close document processor. Close document processor cover. Close front cover. Close left cover #. An original size that cannot be copied has been set. Check the original. • The original was set in a vertical direction during the Book Border Erasure copying operation. Set the original horizontally. • An irregular size original was set during the Border Erase or Combine mode operation. • An original size other than Letter, Ledger, A3, A4R, A5R, B4 or B5R was set to make a split copy or a 2-Sided Copy from a double-page spread original. A size that cannot be copied on both sides has been specified. 2-Sided copies cannot be taken when A6R, B6R, Postcard, Irregular Size or the paper size has not been specified. Specify a paper size that can be used. Make a note of the C and the number (C# # # #). Turn the power switch OFF, unplug the power cord and contact your service representative. The Document Processor is open. Close the Document Processor. The left cover of the Document Processor is open. Close the left cover. Close the front cover. The front cover of the copier is open. Close the front cover. The left cover of the cassette is open. Close the left cover as displayed in place of #. 7-4