Kyocera TASKalfa 5500i 3500i/4500i/5500i Operation Guide Rev-1 2011.4 - Page 513
Mailbox, Finishing the manual staple mode
View all Kyocera TASKalfa 5500i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 513 highlights
Use the buttons on the stapling control section of the Finisher (optional) for manual stapling. Stapling position lamps Stapling position button Stapling button / lamp 1 Press the stapling position button on the stapling control section. The shutter of the paper exit area is opened and this equipment enters into the manual staple mode. 2 Press the stapling position button to select the stapling position (Back / Front / 2 Points ). Operation is not possible while the stapling position lamps are blinking. Operate after the lamps light solidly. 3 Straighten the edges of the paper well and place the paper front side down in the shutter opening of the output unit. If the near side of the paper ( ) will be stapled, place the paper against the front guide (A). If the far side of the paper ( ) will be stapled, place the paper against the back guide (B). If the edge of the paper ( ) will be stapled at two points, B place the paper with the center aligned to the center point between the two side guides (A and B). A CAUTION: Do not insert your hand inside the open shutter. NOTE: Press the stapling position button before you place the paper. Once the paper is placed, the stapling position button cannot be used. The stapling lamp lights when the paper is properly placed. If it does not light, replace the paper. 4 Let go of the paper, and then press the stapling button. Stapling starts. Stapling finishes and the output is delivered to tray A. CAUTION: Be sure that your hands are away from the paper while stapling is in progress. Finishing the manual staple mode Press the stapling position button several times until the stapling position lamps turn off. The shutter of the paper exit area closes. It means that manual stapling is finished. If no operation is performed for approx. 10 seconds, the manual staple mode will be automatically finished. NOTE: The time after which manual staple mode is automatically exited can be changed. For details, refer to Manual Staple on page 9-38 Mailbox Makes it easy to sort output into separate trays. Installing this option adds 7 output trays. When multiple computer users share the printer, each user can print to a specified tray. Installs on the 4,000-sheet finisher. NOTE: To deliver output to the mail box, change the Paper Output selection on the operation panel or in the printer driver, or change in the default settings. (For details, refer to Paper Output on page 9-15.) Appendix-5