LG 26LH1DC5 Owner's Manual - Page 52
Commercial Mode, Installer Overview
View all LG 26LH1DC5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
COMMERCIAL MODE COMMERCIAL MODE INSTALLER OVERVIEW Following is the Commercial Mode Operation Setup. Operating Installer Menu To set up the controls for the TV you will need to know how to enter the 26LH1DC3/4/5 Installer menu and make changes to the default values as required. If necessary, familiarize yourself with the 26LH1DC3/4/5 Installer menu and how to make and save changes in the menu. Optional Installer Remote You will need an Installer remote control similar to the one shown to the right. The TV's clonable features need to be set up before 2-5-5 + Menu is done. This is a critical step. If the Master TV display panel's clonable features like: Clock Set, adding channel icons and channel labels, etc. are not done properly, then the cloned 26LH1DC3/4/5 TVs will all have problems. For example, do not do 2-5-5 + Menu more than once or the TV setup will become corrupted. If you need to start the procedure over, then begin by setting installer item 117 to 001, and pressing Enter to reset the TV to default values in the installer menu. You can do 2-5-4 + Menu mode more than once but this mode is limited to only editing channel icons and channel labels. Refer to the appropriate section in the Manual for other TV features: Picture, Sound etc. *Note: Digital Font options are available only after a channel search has been run and when the TV is tuned to an active digital channel with digital captions. LODGING PTC INSTALLER MENU 000 INSTALLER SEQ 000 UPN 000-000-000-000 FPGA 09F1 PTC V1.00.000 CPU V1.01.00 Typical Installer Menu LT2002 Clone Programmer As the cloning procedure is being performed, specific steps need to be done at the indicated times to achieve the desired result. Be sure to do each cloning task as indicated. If a procedure or step is left out or not performed correctly, then the TV setup will be wrong and cloning may not work. At each step, pay attention to assure the TV screen shows the proper message(s) when cloning. If the message indicated does not appear, there is a problem with that step ¤ and cloning may not be successful. Cloning is only QuickSet II Programmer LT2002 possible when the signal source is an Analog channel, not a digital channel. 52