LG DLG2524W Owners Manual - Page 16

Review the following options to determine the appropriate electrical connection for your home: Use the instructions at this section if your home has a 4-wire receptacle (NEMA type 14-30R) and you will be using a UL listed, 120/240 volt minimum, 30 amp, dryer power supply cord. Use the instructions at this section if your home has a 3-wire receptacle (NEMA type 10-30R) and you will be using a UL listed, 120/240 volt minimum, 30 amp, dryer power supply cord. @ 4!wiledirect If this type is available at your home. you will be connecting to a fused disconnect or circuit breaker box 3!wire direct If this type is available at your home. you will be connecting to a fused disconnect or circuit breaker box 16 Important : use 4-wire connection in the places such as mobile homes and areas where 3-wire connections is not available. Prepare minimum 5fl(l.52m) of length in order t_r dryer to be replaced. First, peel 5 inch (12.7cm) of covering material from end. Make a 5 inch of ground wire bared. After cutting 172 inch (3.8cm) from 3 other wires, peel insulation back linch (2.5cm). Make ends of 3 wires a hook shape. Then, put the hooked shape end of the wire under the screw of the terminal block(hooked end facing rightward) and pinch the hook together and screw tightly. 1. Connect neutral wire(white) of power cord to center terminal block screw. 2. Connect red and black wire to the left and right terminal block screws. 3. Connect ground wire(green) of power cord to external ground screw and move neutral ground wire of appliance and connect it to center screw. 4. Make sure that the strain relief screw is tightened. and be sure that all terminal block nuts are on tight and power cord is in right position. Center terminal block screw(silver) Neutral grounding wire(white) Neutral wire (white or center wire) Strain relief Green wire of power cord External ground connector