LG DX540 Owners Manual - Page 37
Tighten the screws you removed in step 3., Make sure it is inserted correctly.
View all LG DX540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Information Replacing the Lamp 1 Turn off the projector and unplug the power cable. Carefully place on a cushioned surface. (Allow the lamp to cool for 1 hour before removing the used lamp from the projector.) 2 Unscrew the screw from the lamp cover using a screwdriver. Lamp case screw After lifting the lamp cover off, remove the two 3 retaining screws on the lamp case with a screwdriver. 4 Lift the lamp up from the projector. Screws Knob 5 Pull out the handle slowly and remove the lamp case. 6 Insert the new lamp gently into the correct position. Make sure it is inserted correctly. 7 Tighten the screws you removed in step 3. (Make sure they are fixed firmly.) 8 Close the lamp cover and install the screws from step 2 to install the cover. (If the lamp cover is not installed correctly the unit will not power on.) Using another manufacturers lamp may cause damage to the projector or lamp. Make sure the lamp cover is securely fastened. If the lamp cover is not installed correctly the unit will not power on. If this fault persists contact an LG Authorized Service Center. 37