LG L26W58HA Operation Guide - Page 43
assumed, Zn, the, not a, equipment, CLONE, CONTROL
View all LG L26W58HA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Connections for the LT2002 C{one Programmer to Learn the L26W58HA Master TV Setup. ! Antenna or CA]'V ! ! ! ! lI I | | I 'I Ferrite Core (TDK_ ZCAT 2035°0930) s % ,, , % / ! Warning: Do not use LT2002 if a LodgeNet PPV card is installed in TV or c[o_ programmer device w_[[ damaged. Maser L26W58HA C_one P_'ogrammer *Note: It is assumed that the L26W58HA is connected to a signal source, the source selected is Antenna (RF) Zn, the signal is from an Analog channel, not a digital channel, all equipment is connected to power and turned on and the LT2002 Clone Programmer main menu (THE CLONEHAS CONTROLOF THE 7_) menu is displayed on the 7V screen, the clone programmer LED is blinking the required heart beat pattern, see above and next page_ *Note: Once the clone is connected, do not touch the unit or otherwise disturb it or the MPI connections. Any disturbance while the clone is operating may disrupt the master setup transfer or copying etc. Before you begin cloning... • The Master L26W58HA shouW be connected to a good, stabte signal from an over,the-air antenna or cabte service Analog channel and connected to power, (See above,) o Teaching and Learning is onty possible between identica[ mode[ devices. (However, the L_[2002 Clone programmer can store up to 3 different 'mastefl setups.) WARNING: Copying a bIank or incorrect memory into a 1V, STB or other device wilt cause the TV, STB or other device to operate erraticatly or become inoperable. , Use an Insta[ter's remote to operate Learning and Teaching menus. • Rake sure that the batteries in the Clone programmer are fresh. • [I[ batteries are removed, the Clone Clock time witt be lost. • Decide if you want to set the t_me from the Crone programmer or copy the time to the Clone programmer; from a compatible TV which has the dock set to the current t4me. • Setting the time and transferring it to the Clone or other de_ce is a separate procedure, • Fot[ow the connection d_agram above to connect the Crone to a _4aster L26W58HA T'¢ display pane[. After [earning is corn° p[ete, to another identical L26W58HA TV display panet to "teach" it the master setup, • Afte_ the L26W58HAs setup has been copied to another identicat L26W58HA, that identica[ unit with the copied setup, needs to be disconnected from power for about 15 seconds to activate the newtyoc, opied setup. • See the Clone T_oub[eshooting section to resolve problems. Turn to the next page to continue Goning Setup. PAGE 43