LG L26W58HA Operation Guide - Page 58

Some quick and easy tips to resolving problems Symptoms Power No Power. Possible Cause(s) See troubleshooting flow chart. Possible Solution(s) Display Pane[ Picture No Picture. • Display panel is turned off. • Antenna/Cable not connected. • Connections incorrect. • M.P.I. not connected. • Encrypted program. • Wrong tuning band. -Turn TV on. -Power failure? Connect Antenna/Cable signal source to L26W58HA. -Check connections on L26W58HA. -If applicable, connect M.P.I. cable to M.P.I. device. -Try another channel. -Adjust Installer menu settings. Erratic Operation Installer menu setup. • Wrong Installer menu settings. • Software problem. -Adjust Installer menu settings as required. Remove TV power cord for 15 seconds. Remote Control Remote doesn't work. • Remote not in TV mode. • Not aimed at 1R remote sensor. • Remote too far from TR sensor. • IR path to TV's receiver obstructed. • Weak batteries. • Wrong battery polarity. • Too much light in room. • Wrong Installer remote control. • Incorrect Bed 1-2 setting. -Use Mode key to select TV; puts remote into L26W58HA mode. -Point remote at TV's IR receiver on TV. -Move remote closer to TV's TR receiver or darken room. -Remove obstructions. -RepLace batteries. -Check that "+" and "-" match in battery compartment. -Dim room Light. -Requires compatible Installer remote, contact your LG dealer. -Set correct Bed 1-2 setting. Picture Reception Normal picture, poor or no sound. • Audio muted. • Broadcast problem. -Press MUTE or use VoLuore Up key to increase sound Level. -Try a different channel. Broadcast Tuning No Information available display, Mode Digital Channel OSD • Etem 103 set to 1 physical channels tuning, -Set Etem 103 to 0 for information to be added to virtual channel tuning digital OSD. *Note: For other problems not caused by the L26W58HA, refer to other devices" operoting guide. See Page(s) 60 9-11 7 / 9-15 46N51 46N51 19_20 41 10 19_20 1g_20 46_51 PAGE 58