LG L26W58HA Operation Guide - Page 44

Instructions for the CLone Programmer to Learn the Master L26W58HA Setup. Use MPT Cable to Connect LT2002 CLone Programmer to Master L26W58HA MPT Port If there is a good connection, "THE CLONEHAS CONTROLOF TV" nlessage will appear. Press any key on the [nsta[Ler remote. Learn Setup from Master L26W58HA Press I to select the "LEARN FROMTV" option, then press ON/OFF, POWER,or ENTERto go to the Memory Bank Selection Menu. Pick the Memory "Bank" you want to store the master L26W58HAs setup in by pressing either Channel key repeatedly to choose Memory I, 2 or 3. (If you choose a Memory "Bank" that has a master device's setup programmed into it, that setup wiU be overwritten by the new master L26W58HA's setup.) Once the CLonememory bank is selected, press ON/OFF, POWER,or ENTER.The CLone memory bank you have selected wiU be shown. Press ON/OFF or POWERto begin copying the master L26W58HA's setup. Set the CLock (Optional) Set the time on a Master TV's CLock. (Tf the time has already been copied from a TV into the CLoneprogrammer, you can set a master TV's clock by copying the time from the CLone programmer.) The CLone Programmer can copy the current time to both a master TV and to the CLone'sinternal clock; accurate to within one minute. (Another reason that the CLoneprogrammer should be equipped with fresh, high-quality alkaline batteries, is for it to keep the time as accurately as possible.) Since the CLone Programmer's time cannot be set directly, the current time needs to be copied from a Zenith/LG TV equipped with M.P.f. input capability. After the time is copied to the CLoneprogrammer, the current time can then be transferred to another TV. (This can be a master TV, or another TV which has already had the features set up.) *Note: When using the clone programmer.for teaching or learning, be sure that the heartbeat pattern is shown on the LEDs. Both learning and teaching should take about 45 or more seconds depending on the complexitsl of the master setup. While the clone is functioning, do not move it or otherwise disturb the clone or wiring connections, ff the clone finishes the function in less than 45 seconds, redo the function again. Press the reset button if the clone does not act nomTally. THE CLONE HAS CONTROL OF THE TV THE CLONE IS VERSION XX THE TV IS VERSION XX THE SW IS REVISION XX CLONE CLOCK= TV CLOCK= XX:XX XX:XX -PRESS ANY KEY TO CONTINUE. DISCONNECT CLONE WHEN DONE. This menu should appear by itself after the LT2002 is connected to the L26W58HA MPf port. CLONE SELECTION MENU (1) LEARN FROM TV (2) TEACH TO TV (3) SET CLONE CLOCK FROM TV (4) SET TV CLOCK FROM CLONE (5) DISPLAY TV SETUP (6) DISPLAY CLONE SETUP TO CHANGE MENU ITEMS, PRESS CHANNEL KEYS OR DIGITS. - TO EXECUTE ITEM, PRESS ON/OFF, POWER, OR ENTER LT2002 CI,one Programmer Communication Problems • A slow flashing green light indicates there are communication problems between the LZ6W58HA and the LT2002 clone programmer. Tf this is the case, check for a damaged cable, poor contacts, or other connection troubles. • Zf the status indicator is red, the programmer batteries are low and should be replaced. Install _ high-quality alkaline AA batteries. PAG E 44