LG LSE4615ST Owners Manual - Page 18
Engaging the Anti-tip Device, Optional Rear Filler, Test Run
View all LG LSE4615ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
18 INSTALLATION Engaging the Anti-tip Device •• Move the range close enough to the opening to plug into the receptacle. •• Slide the range into position ensuring that the back leg slides under the anti-tip bracket. The range should sit flush against the back wall when properly installed. •• Carefully attempt to tip the range forward to ensure that the anti-tip bracket is engaged properly. If properly installed, the anti-tip bracket will prevent the range from being tipped. If the range can be tipped, reinstall the range until the anti-tip bracket is properly installed and the range will not tip forward. •• Turn on electrical power. Check the range for proper operation. Optional Rear Filler If the counter does not bridge the opening at the rear wall the rear filler kit, that is provided with the slide in range, will be needed. NOTE If the countertop depth is greater than 25" there will be a gap between the filler kit and the back wall. If the countertop depth is less than 24", the control panel will not sit flush with the countertop. Installing the Rear Filler 1 Using a screwdriver, Remove the three screws holding the rear bracket in place. Rear bracket 2 Attach the rear bracket and filler assembly as shown, using three screws removed in step 1. Rear filler Test Run Check if the range is properly installed and run a test cycle. 1 Before using the cooktop for the first time, clean it with a ceramic cooktop cleaner. This helps protect the top and makes cleanup easier. 2 Turn the oven mode knob to the Off position to start test. 3 Turn each knob to the Hi position to check that the surface heating elements are working properly. The elements should glow red and radiate heat, and they should cycle on and off periodically even when the knob is in the Hi position. This cycling prevents the glass-ceramic from being cracked by thermal shock. IMPORTANT : The Warming Zone does not consume enough power to glow red. 4 *For Model : LSE4615 / LSE4613 After checking all the surface heating elements, check the locking system by pressing Clock for three seconds. The oven door should lock and the cooktop should not operate while the Lockout function is turned on. Pressing Clock for three seconds to disable Lockout. 5 Now check the oven's operation. Turn the oven mode knob to select the Bake mode. 350 °F appears in the display. Press Start. 6 The oven should finish preheating in 15 minutes, and the convection fan should operate while the oven is preheating. 7 After checking the oven's operation, turn the temperature up to 450 °F and leave the oven on for at least an hour to help remove any oil which might cause smoke and odors when first using the oven. NOTE Smoke may come out of the range when it is first used.