LG LWHD1800HR Service Manual - Page 13

Operation - how to set timer

Page 13 highlights

Installation Operation • VENTILATION The ventilation lever must be in the CLOSE position in order to maintain the best cooling conditions. When a fresh air is necessary in the room, set the ventilation lever to the OPEN position. The damper is opened and room air is exhausted. 23 7 4 5 6 CLOSE VENT OPEN REMOTE CONTROLLER 8 5 1 3 7 Power 1 Temp Fan Speed 4 Timer Mode 2 Energy Auto Saver Swing 6 1. POWER BUTTON To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again. This button takes priority over any other buttons. 2. OPERATION MODE SELECTION BUTTON Everytime you push this button, it will toggle COOL, FAN and HEAT. 3. ON/OFF TIMER BUTTON Everytime you push this button, timer is set as follows.(1Hour ➔ 2Hours ➔ 3Hours ➔ 4Hours ➔ 5Hours ➔ 6Hours ➔ 7Hours ➔ 8Hours ➔ 9Hours ➔ 10Hours ➔ 11Hours ➔ 12Hours ➔ Cancel) 4. FAN SPEED SELECTOR Everytime you push this button, it is set as follows. (Hi[ ] ➔ Low[ ] ➔ Hi[ ]....) 5. ROOM TEMPERATURE SETTING BUTTON This button can automatically control the temperature of the room. The temperature can be set within a range of 60°F to 86°F by 1°F. 6. AUTO SWING This button can automatically control the air flow direction. 7. ENERGY SAVER The fan stops when the compressor stops cooling. Approximately every 3 munutes the fan will turn on and check the room air to determine if cooling is needed. 8. REMOCON SIGNAL RECEIVER CAUTION: A slight heat odor may come from the unit when first switching to HEAT after the cooling season is over. This odor, caused by fine dust particles on the heater, will disappear quickly. 13 Room Air Conditioner

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31

13
Room Air Conditioner
Installation
Operation
Power
Temp
Fan Speed
Timer
Mode
Energy
Saver
Auto
Swing
1
4
2
6
7
3
5
REMOTE CONTROLLER
1
7
8
5
4
6
2
3
1. POWER BUTTON
To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
This button takes priority over any other buttons.
2. OPERATION MODE SELECTION BUTTON
Everytime you push this button, it will toggle COOL, FAN and HEAT.
3. ON/OFF TIMER BUTTON
Everytime you push this button, timer is set as follows.(1Hour
2Hours
3Hours
4Hours
5Hours
6Hours
7Hours
8Hours
9Hours
10Hours
11Hours
12Hours
Cancel)
4. FAN SPEED SELECTOR
Everytime you push this button, it is set as follows. (Hi[
]
Low[
]
Hi[
]
....
)
5. ROOM TEMPERATURE SETTING BUTTON
This button can automatically control the temperature of the room.
The temperature can be set within a range of 60°F to
86°F by 1°F.
6. AUTO SWING
This button can automatically control the air flow direction.
7. ENERGY SAVER
The fan stops when the compressor stops cooling.
Approximately every 3 munutes the fan will turn on and check the room air to determine if cooling is needed.
8. REMOCON SIGNAL RECEIVER
CAUTION: A slight heat odor may come from the unit when first switching to
HEAT after the cooling season is over. This odor, caused by fine dust particles on
the heater, will disappear quickly.
CLOSE
VENT
OPEN
• VENTILATION
The ventilation lever must be in the CLOSE position in
order to maintain the best cooling conditions.
When a fresh air is necessary in the room, set the ven-
tilation lever to the OPEN position.
The damper is opened and room air is exhausted.