LG LWHD1800HR Service Manual - Page 14
Disassembly
View all LG LWHD1800HR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Disassembly Disassembly - Before the following disassembly, power switch is set to off and disconnected the power cord. Mechanical parts 1. Front grille 1. Open the inlet grille upward or downward. 2. Remove the screw which fastens the front grille. 3. Pull the front grille from the right side. 4. Remove the front grille. (See Fig. 16) 5. Re-install the component by referring to the removal procedure. NOTICE Mark ∆ of inlet grille means opening direction. 2. Cabinet 1. After disassembling the front grille, remove the screws which fasten the cabinet at both sides. Keep these for later use. 2. Remove the two screws which fasten the cabinet at back. (See Fig. 17) 3. Pull the base pan forward. Figure 16 3. Control box 1. Remove the front grille. (Refer to section 1) 2. Pull the base pan forward so that you can remove the 2 screws which fasten the cover control at the right side. (See Fig. 18) 3. Remove the 3 screws which fasten the controlbox. (See Fig. 18) 4. Discharge the capacitor by placing a 20,000 ohm resistor across the capacitor terminals. 5. Disconnect two wire housings in the control box. 6. Pull the control box forward completely. 7. Re-install the components by referring to the removal procedure. (See Fig. 18) (Refer to the wiring diagram found on page 29~30 in this manual and on the control box.) Figure 17 Figure 18 Service Manual 14