LG MHEC1737F INSTALLATION - Page 10

us_main.book.book Page 10 Thursday, November 25, 2021 10:15 AM 10 INSTALLATION and one or two blower unit mounting screw(s) i. 5 Rotate and reinstall the blower unit a so that the exhaust ports b face the rear of the cabinet and are aligned with the rear knockouts. When you insert the blower unit, the blower wire c must be routed as shown. f Blower unit g Knockouts h Back plate 2 Carefully lift the blower unit out of the microwave oven. 6 Attach the blower plate d to the microwave oven so the blow unit exhaust ports c and blower plate opening are aligned. Attach one or two blower unit mounting screw(s) f and then one or several blower plate mounting screw(s) a. Attach the cover plate g on the blower plate with a screw h. 3 Use side cutters or tin snips to cut out and remove the knockouts b from the back plate a. Be careful not to distort the back plate. Discard the knockouts. 4 To avoid pinching the blower wire, make sure that it is channeled underneath and between the two exhaust ports when they are rotated. b Blower unit e Back plate 7 Insert the tabs on each side of the damper into the holes at the inside rear of the adapter. Attach the exhaust adapter a to the back plate wall side. Push in securely until it is past the top locking tabs c and in the lower locking tabs c. Make sure that the damper hinge is at the top and that the damper swings freely. b Damper (hinge side up) c Guides e Slide exhaust adapter into guides on rear panel.