LG WT5001CW Owner's Manual - Page 11
Connecting The Water Lines, Connecting The Drain Line - leaking
View all LG WT5001CW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
ENGLISH INSTALLATION INSTRUCTIONS CONNECTING THE WATER LINES • IMPORTANT: Use new hoses when installing the washer. Do NOT reuse old hoses. • IMPORTANT: Use ONLY the inlet hoses provided by LG with this laundry product. Aftermarket hoses are not guaranteed to fit or function correctly. Other hoses may not tighten correctly and could cause leaks. Subsequent damage to product or property will not be covered under the terms of LG's warranty. • Water supply pressure must be between 14.5 PSI and 116 PSI (100~800 kPa). If the water supply pressure is more than 116 PSI, a pressure reducing valve must be installed. • Periodically check the hose for cracks, leaks, and wear, and replace the hose every 5 years. • Make sure that the water lines are not stretched, pinched, crushed, or kinked. • The washer should never be installed or stored in a location subject to freezing temperatures. Damage to the water lines and internal mechanisms of the washer can result. If the washer was exposed to freezing temperatures prior to installation, allow it to stand at room temperature for several hours before use. 1 Inspect the threaded fitting on each hose and make sure there is a rubber seal in place in both ends. Water Hose (to water inlet on washer) Rubber Seal Rubber Seal Water Hose (to tap) 2 C onnect water hose to hose utilities. Connect the water hoses to the HOT and COLD water valves of your home. Hand tighten, plus make an additional 1/4 turn with pliers. NOTE: A water heater set to deliver 120°F (49°C) water to the washer. Water Tap NOTE: To avoid build up that can clog the inlet valve screen, thoroughly flush both faucet and hose to remove any particles or other impurities by running water through them into a container. 3 Attach water hose to washer. Thread the hot water hose onto the washer hot water connection (red) and the cold water hose onto the cold water connection (blue). Hand tighten; then make an additional 1/8 turn with pliers. Hot Cold NOTE: Do not cross-thread the hose fittings. Attach the hot water line to the red hot water inlet on the back of the washer. Attach the cold water line to the blue cold water inlet on the back of the washer. Tighten the fittings securely. NOTE: Tighten the fittings securely. Open the water taps fully to check for leaks. CONNECTING THE DRAIN LINE • The drain hose should always be properly secured. Failure to properly secure the drain hose can result in flooding and property damage. • Do not install the end of the drain hose higher than 96 inches (243.8 cm) above the bottom of the washer. • The drain must be installed in accordance with any applicable local codes and regulations. • Make sure that the water lines are not stretched, pinched, crushed, or kinked. Drain Hose Standpipe 39″ (99 cm) 11