Lantronix EDS8PS EDS - User Guide - Page 28
Restore factory defaults:, Installing the EDS8/16PS, Finding a Suitable Location
View all Lantronix EDS8PS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
3: Installation of EDS8PS and EDS16PS 1. Press and hold the reset button for about 3 seconds. The status LED blinks quickly. 2. When the fast blinks stop, release the button. When the unit reboots, the status LED changes from a fast blink to a solid ON. Restore factory defaults: 1. Press and hold the reset button for about 11 seconds. The LED blinks quickly for about 3 seconds, then comes on for about 5 seconds, then blinks slowly for about 2 seconds. 2. When the slow blinks stop, release the button. Installing the EDS8/16PS Finding a Suitable Location You can install the EDS8/16PS either in a shelf or as a desktop unit. If using AC power, avoid outlets controlled by a wall switch. Connecting the EDS8/16PS All EDS serial ports support RS-232 devices. Connect the EDS8/16PS to one or more serial devices. 1. Power off the serial devices. 2. Attach a CAT 5 serial cable between the EDS8/16PS and your serial device. See the Appendix D - Lantronix Cables and Adapters (on page 158), for a list of cables and adapters you can use. 3. Connect an Ethernet cable between the EDS8/16PS Ethernet port and your Ethernet network. 4. Insert the power cord into the back of the EDS8/16PS. Plug the other end into an AC wall outlet. 5. Power up the serial devices. EDS User Guide 28