Lantronix SISPM1040-3166-L Installation Guide Rev G - Page 24

Lantronix SISPM1040-3xxx-L Install Guide Port Status LEDs: LED TP Port SFP Port SFP+ Port Color Green/Amber Green/Amber Blue/Green Function Light off: port disconnected or link failed Green Light on: link-up (1G) Amber Light on: link-up (10/100M) Blinking: activity (receiving or transmitting data) Light off: port disconnected or link failed Green Light on: link-up (1G) Amber Light on: link-up (100M) Blinking: activity (receiving or transmitting data) Light off: port disconnected or link failed Blue Light on: link-up (10G) Green Light on: link-up (1G) Blinking: activity (receiving or transmitting data) Reset Button Press to toggle the LED indicators to display Link/Activity/Speed or just display PoE port status. By pressing the Reset button for certain period of time, you can: • Reset the Switch: to reboot and get the switch back to the previous configuration settings saved. • Restore the Switch to Factory Defaults: To restore the original factory default settings back to the switch. Note: Based on the table below, determine which task is being performed by reading the LED behaviors while pressing the Reset button. When LED behaviors are correctly displayed, just release the Reset button. The front panel LEDs flash in a sequence that takes approximately 15-30 seconds. When the front panel LEDs quit flashing you can continue operation. Table 4: Reset Button Operation Task to Perform Reset the Switch Press Reset for 2 ~ 7 seconds SYS LED Behavior Blinking Green Port Status LED Behavior All LEDs Off Restore to Defaults 7 ~ 12 seconds Blinking Green All LEDs On 33762 Rev. G https://www.lantronix.com/ Page 24 of 48