Lantronix XPress-DR UDS1100-IAP - Multi-Master DF1 Protocol User Guide - Page 13
Save, Quit, or Reset the Configuration
View all Lantronix XPress-DR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
3: Configuring Multi-Master DF1 Save, Quit, or Reset the Configuration Multi-Master DF1 1) TCP/IP Network Settings: Ethernet Autodetect IP addr 192.168.0.249, gateway 192.168.000.001 2) DF1 Settings: Protocol DF1 Full-Duplex Serial Interface ......... RS232 9600,8,N,1 Check Sum CRC (16-bit) Redirector Sockets ....... 3 (port:03001) Raw Tunneled Sockets ..... 1 (port:10001) 3) MSG Block Remote IP Routing Table: 000-100: 192.168.000.024 (* Fixed IP *) 101-254: 192.168.000.000 (* DST as low octet of IP *) R)eset all to factory Defaults S)ave all to EEPROM and Quit Q)uit without saving Select Command or parameter set (1,2,R,S,Q) to change: 1. Review your entries. 2. You have the following options: To save the configuration and exit, type S on the command line. This saves the parameters to EEPROM. Caution: DO NOT POWER CYCLE the unit too fast after doing this. Allow the unit to reboot naturally one time first. To quit without saving, type Q on the command line. The unit reboots. To restore the default values, type R on the command line. Multi-Master DF1 Protocol User Guide 12