Lenovo S205 Hardware Maintenance Manual - Page 136
Disconnect
View all Lenovo S205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Replacing the system board This procedure describes how to remove and replace the system board. The procedure varies depending upon the machine type. Types 7816, 7817, 9686 and 9687 Important The heat sink and microprocessor might be very hot. Make sure these components are cool enough to safely handle before continuing this procedure. 1. Remove the side cover. See "Removing the cover" on page 123. 2. Place the computer on its right side to help make the system board more accessible. 3. Remove any adapter cards installed in the PCI connectors. 4. Disconnect the signal and power cables from the hard disk drive. 5. Press the release tab 1 down, slide the hard drive cage 2 back, and pivot the hard disk drive outward as shown. 6. Carefully take note of the location of all cable connections on the system board and disconnect all cables. See the system board illustration for your machine type at "Locating parts on the system board" on page 125. 7. Remove the screws that secure the system board to the chassis. 8. Lift the system board out of the chassis. 9. Remove the memory modules from the failing system board and install them in the same location on the new system board. 10. Disconnect the heat sink and fan assembly cable from the system board. See the system board illustration for your machine type at "Locating parts on the system board" on page 125. 130 Hardware Maintenance Manual