Lenovo S205 Hardware Maintenance Manual - Page 74
X-XXX
View all Lenovo S205 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Diagnostic Error Code 025-198-XXX IDE interface test aborted 025-199-XXX IDE interface test failed, cause unknown 030-000-XXX SCSI interface Test Passed 030-00X-XXX 030-01X-XXX SCSI interface failure 030-027-XXX SCSI interface Configuration/Setup error 030-03X-XXX 030-04X-XXX SCSI interface error 030-195-XXX SCSI interface Test aborted by user 030-196-XXX SCSI interface test halt, error threshold exceeded 030-197-XXX SCSI interface test warning FRU/Action 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 51 2. Flash the system and re-test. See "Flash update procedures" on page 243 3. Go to "Undetermined problems" on page 81 1. Go to "Undetermined problems" on page 81 2. Flash the system and re-test. See "Flash update procedures" on page 243 3. Replace component under function test No action 1. SCSI signal cable 2. Check power supply 3. SCSI device 4. SCSI adapter card, if installed 5. System board 1. SCSI signal cable 2. Flash the system. See "Flash update procedures" on page 243 3. SCSI device 4. SCSI adapter card, if installed 5. System board 1. SCSI signal cable 2. Check power supply 3. SCSI device 4. SCSI adapter card, if installed 5. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6, "Using the Setup Utility," on page 51 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 68 Hardware Maintenance Manual