Lexmark 352dn Menus and Messages Guide - Page 10

Using printer menus Universal Setup This menu selection is used to specify the height and width of the Universal Paper Size. By specifying the height and width for Universal Paper Size, the printer will use the Universal setting exactly like other paper sizes, including support for duplex and n-up. Menu selection Units of Measure Portrait Width Portrait Height Feed Direction Purpose Values Determines the unit of measure used to Inches enter the Universal Height and Width Millimeters Inches is the US default; Millimeters is the international default. Sets the portrait width of the universal media Note: If the value set exceeds the maximum width, the printer will use the maximum value allowed in inches or millimeters. 3 inches to 14.17 inches in 0.01 inch increments 76 mm to 360 mm in 1 mm increments Shows either inches or mm from Units of Measure setting; 11.69 inches is the US default, and 297 mm is the international default. Sets the portrait height of the universal media Note: If the value set exceeds the maximum height, the printer will use the maximum value allowed in inches or millimeters. 3 inches to 14.17 inches in 0.01 inch increments 76 mm to 360 in 1 mm increments Shows either inches or mm from Units of Measure setting; 17 inches is the US default, and 432 mm is the international default. Specifies the feed direction Short Edge* Long Edge Long Edge is only shown if the longest edge is shorter than the Maximum Physical Width of the printer. Substitute Size This menu selection is used to determine whether the printer can substitute another size paper if the requested paper size is not currently installed in any of the printer input sources. If, for example, Substitute Size is set to Letter/A4, and only letter size paper is installed in the printer. When a request is received to print on A4 paper, the printer will substitute letter for A4 and print the job instead of displaying a change paper request. Menu selection Substitute Size Purpose Substitutes the specified paper size if the requested size is not loaded Values Off Statement/A5 Letter/A4 All Listed* The All Listed value indicates that all available substitutions are allowed. Paper Texture This menu selection is used to set the media texture for each of the defined media types. This allows the printer to optimize the print quality for the specified media. Menu selection Plain Texture Card Stock Text Purpose Values Identifies the texture of the media loaded Smooth in a specific input source Normal* Rough Identifies the texture of the card stock loaded in a specific input source Smooth Normal* Rough Shown if Card Stock is supported in the specified input source 10