Lexmark 352dn Menus and Messages Guide - Page 31

Understanding printer messages Message Resetting Maint Cnt Value Resetting PC Cnt Value Resetting the Printer Res Reduced Restoring Factory Defaults Std Bin Full Toner Low Tray Missing USB Waiting 31 Missing or defective cart. 32 unsupported print cartridge 34 Short paper 35 Res save off deficient memory 37 Insufficient collation area 37 Insufficient Defrag memory 38 Memory Full Action The printer is resetting the counter that tracks wear on the fuser. The printer is resetting the counter that tracks wear on the photoconductor. Wait for the message to clear. The printer is reducing the resolution of a page in the current job from 600 dots per inch (dpi) to 300 dpi to prevent a 38 Memory Full error. Res Reduced remains on the display while the job prints. Wait for the message to clear. Note: When factory default settings are restored: • All downloaded resources (fonts, macros, symbol sets) in the printer memory are deleted. • All menu settings return to the factory default setting except: - The Display Language setting in the Setup Menu - All settings in the Parallel Menu, Network Menu, and USB Menu The standard bin is full. • Replace the toner cartridge. • Press to clear the message and continue printing. Insert the tray into the printer. The printer is processing data through the specified USB port. The printer has received a page of data to print, but is waiting for an End of Job command, a Form Feed command, or additional data. • Press to print the contents of the buffer. • Cancel the current job. Insert or replace the toner cartridge. Install a toner cartridge that is the correct type and capacity for this printer. • Load the appropriate media in the selected source. • To clear the message and print the job using a different paper source, press . • To disable Resource Save and continue printing, press . • To enable Resource Save after you get this message: - Make sure the link buffers are set to Auto, then exit the menus to activate the link buffer changes. - When Ready is displayed, enable Resource Save. • Install additional memory. • To print the portion of the job already stored and begin collating the rest of the job, press . • Cancel the current job. • To stop the defragment operation and continue printing, press . • Delete fonts, macros, and other data in printer memory. • Install additional printer memory. • To clear the message and continue printing, press . The job may not print correctly. • Cancel the current job. • Install additional printer memory. 31