Lexmark Optra T Service Manual - Page 245
a jumper between the center pin and pin 5 of J10., Models 414, 41b
View all Lexmark Optra T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
4069-XXX Connector J5 Autoconnect BTM/FNT J6 Engine Board J7 Controller Board J11 INA 1 J12 INA 2 Pin No. 1 2 1 1 1 1 Signal +24 V dc Ground N/A N/A N/A N/A Connector J8 ID-1 J9 ID-2 J10 ID-3 Jumper Position 1 2 3 4 5 6 Signal 0 V dc (Gnd) center pin to top pin of J8 + 5 V dc center pin to bottom pin of J9 0 V dc (Gnd) center pin to top pin of J9 +5 V dc center pin to bottom pin of J9 0 V dc (Gnd) center pin to top pin of J10 +5 V dc center pin to bottom pin of J10 Note: A 902 service error may display if the jumpers are not correctly installed. • Models 010 and 01n have a jumper on J10 between the center pin and pin 5. • Models 212 and 21n have a jumper between the center pin and pin2 of J8, a jumper between the center pin and pin 4 on J9 and a jumper between the center pin and pin 5 of J10. • Models 414, 41b, 41L and 41n have a jumper between the center pin and pin 2 of J8 and a jumper between the center pin and pin 3 of J9. Connector Locations 5-13