Lexmark Optra T Service Manual - Page 98
Operator Panel Display Service Check, If the operator panel is operating properly except for a PEL or
View all Lexmark Optra T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
4069-XXX FRU 2 Engine Board (No buttons work) Action Check the voltage at J11-5. The voltage measures approximately +5 V dc with the controller board removed. If incorrect, replace the engine board. If correct, check the continuity of the operator panel cable. If incorrect, replace the cable. If correct, replace the operator panel assembly. Operator Panel Display Service Check SERVICE TIP: The printer has detected a problem with the engine board, operator panel cable or operator panel assembly if POST does not complete and the printer emits 5 beeps and stops in a continuous pattern until the printer is turned off. The operator panel cable is an individual cable on some printers and a combination cable assembly with the cover switch cable on later models. Note: If the operator panel is operating properly except for a PEL or a few PELS missing or broken, run the "LCD Test" on page 3-9 from the hardware tests before continuing with this diagnostic service check. FRU 1 Operator Panel Cable 2 Operator Panel Display blank, 5 beeps, LED Off 3 Operator Panel Display blank, 5 beeps, LED On Action Check for proper installation of the cable at the engine board (J11) and at the operator panel. Check the continuity of the operator panel cable. If incorrect, replace the cable. Check the voltage at J11-2 on the engine board. It measures approximately +5 V dc. If incorrect, replace the engine board. If correct, replace the operator panel assembly. Check for ground between J13-4 and ground. If correct, replace the operator panel assembly. If incorrect, replace the engine board. 2-70 Service Manual