Lexmark X264dn Service Manual - Page 50

7013-XXX Error Description Action 242.16 Failed to feed from tray 2. Pages in the paper path have been flushed to the output bin. Remove Tray 2 and inspect for obstruction in the paper path. Check the pick tires for wear or paper dust. Replace if necessary. Check the wear strips and replace if necessary. 251.00 251.10 251.11 Paper jam near the manual feeder. Second pick attempt failed from manual feeder. Failed to feed from manual feeder. Pages in the paper path have been flushed to the output bin. Inspect the pick roller on the MPF or the rollers on the manual feed. If the MPF pick roller is damaged or worn, then replace the MPF. For a printer with a manual feed only (no MPF), clean the roller. 251.12 Second pick from manual feeder, tray 1, or feeder failed when media was in the source while the other sheets were committed to the paper path. 251.19 Media never reached the input sensor from the manual feeder. 251.20 The media in the MPF has been pushed in too far. 251.21 The media in the MPF has been pushed in too far. Remove the media, realign the stock, and re-insert. Do not let the top sheets to go beyond the wear strips. 290.02 Scanner ADF Feed Jam. The scanner ADF has failed to feed a page to the ADF interval sensor. Remove the sheet of paper rom the ADF. Retry the job. If the error recurs, see "ADF paper jam service check" on page 2-49. 290.10 Scanner Static Jam - 1st scanner sensor. Scanner Remove all paper from the ADF. Retry the job. If the ADF detects paper at the first scanner sensor while the error recurs, see"ADF paper jam service check" ADF is in an idle state. on page 2-49. 291.00 Scanner Static Jam - 2nd scanner sensor. Scanner ADF detects paper at the second scanner sensor while the ADF is in an idle state. 292.00 Scanner jam, remove all originals from the scanner. This message appears if the ADF cover is open while paper is fed through the ADF. Remove the paper from the ADF, and close the ADF cover. If the error recurs, see "ADF cover open service check" on page 2-48. 293.02 Flatbed cover open. The MFP senses that the flatbed Close the flatbed cover. See "ADF cover open cover is open. service check" on page 2-48. 294.04 294.05 Scanner jam, remove all originals from the scanner. Jam at the ADF exit sensor. Scanner jam, remove all originals from the scanner. A jam is detected at the ADF exit sensor. 294.06Remove all paper from the ADF. If the error recurs, see "ADF paper jam service check" on page 2-49. 294.06 ADF Backfeed Jam. A jam is detected at the ADF exit sensor. 2-16 Service Manual