LiftMaster 8550 8550 Manual - Page 33

To Erase the Memory, Remote Controls

Get LiftMaster 8550 PDF manuals and user guides View all LiftMaster 8550 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

Remote Controls 3 Using a safety pin or paper clip, press the program button until the LEDs on the front of the remote control turn on. 4 Press and release the Learn button on the garage door opener. The Learn LED will light. Within 30 seconds... 5 Press and release the remote control button you want to use... Check to see if the garage door opener light bulb blinks. If not, wait for the remote control LED to light solid then slowly press and release the remote control button again. Repeat until the light bulb blinks. DO NOT press the button after the light bulb blinks. 6 To exit programming mode, press any remote control button except the button that was just programmed. 7 To test, press the programmed button on the remote control... The garage door opener will activate. To Erase the Memory ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES 1 Press and hold the learn button on garage door opener until the learn LED goes out (approximately 6 seconds). All remote control and keyless entry codes are now erased. Reprogram any accessory you wish to use. ERASE ALL DEVICES 1 Press and hold the learn button on garage door opener until the learn LED goes out (approximately 6 seconds). 2 Immediately press and hold the learn button again until the learn LED goes out. All codes are now erased. Reprogram any accessory you wish to use. 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
33
3
Using a safety pin or paper clip, press the
program button until the LEDs on the front of
the remote control turn on.
4
Press and release the Learn button on the
garage door opener. The Learn LED will light.
Within 30 seconds...
5
Press and release the remote control button you want to use...
Check to see if the garage door opener light bulb blinks. If not, wait for the remote control LED to
light solid then
slowly
press and release the remote control button again.
Repeat
until the light bulb blinks.
DO NOT
press the button after the light bulb blinks.
6
To exit programming mode, press any remote control button
except
the button that was just
programmed.
7
To test, press the programmed button on the remote control... The garage door opener will
activate.
To Erase the Memory
ERASE ALL REMOTE CONTROLS AND KEYLESS ENTRIES
1
Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds). All remote control and keyless entry codes are now erased.
Reprogram any accessory you wish to use.
ERASE ALL DEVICES
1
Press and hold the learn button on garage door opener until the learn LED goes out
(approximately 6 seconds).
2
Immediately press and hold the learn button again until the learn LED goes out. All codes are
now erased.
Reprogram any accessory you wish to use.
Remote Controls