LiftMaster LMSC1000 Installation Manual - English French Spanish - Page 4

Reader Wiring Diagram Power Transformer LMSC1000 RFID Reader The gray, blue, and brown wires from the RFID Reader are unused. Solid Black Black w/Dash Red Black Green White Yellow White Green Black Power +12 V RESET - 12 VDC (GND) Loop GND LP_INL +12 V LP_INH - 12 VDC (GND) Serial SER IN PWR RF PWR SET LP SET/ERR SER I SER OUT SER 0 WO GND Wiegand DATA 1 SETUP 6 DC LOOP 5 8SEC 4 4SEC 3 Dry Cont 2SEC 2 1SEC 1 NO CONN DATA 0 ON - OFF A GND B Door 1 Door 2 WIEGAND INPUT WIEGAND INPUT Arming Loop Detector (Optional) Set Switch #5 to "ON" to enable. Arming Loop Detector Low Voltage Light Normally Open Common 24 Volts AC/DC 1 Amp max. Gate Operator Normally Open Common REQUEST TO EXIT STATUS PRIMARY RELAY AUXILIARY RELAY WIEGAND OUTPUT STATUS REQUEST TO EXIT PRIMARY RELAY AUXILIARY RELAY Access Control System ON Wiegand Interface Module LEDs Power Serial Wiegand RESET Loop PWR RF PWR SET LP SET/ERR SER I SER 0 WO SETUP 6 DC LOOP 5 8SEC 4 4SEC 3 2SEC 2 1SEC 1 ON - OFF Dry Cont PWR LP SET/ERR SER I SER 0 WO DC 6 5 DOOR BOARD 1 Green (PWR) Green (LP) Blue (SET/ERR) Red (SER 1) Yellow (SER 0) Orange (W0) Orange (DC) Power (Solid when power present) Arming Loop (Solid when active) Data Error Received from Reader Data Received from Reader (Flash) Data Transmitted to Reader (Flash) Wiegand Data Output (Flash) Relay Control Output (Flash) 4