Linksys EFG80 User Guide - Page 5
Disk Full, Backup, Reset Button, Uplink Button, LAN Port, Drive LEDs, Ready, Error - firmware
UPC - 745883552726
View all Linksys EFG80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
EtherFast 10/100 Instant GigaDrive Reset Button If the Instant GigaDrive's IP Address or password is lost, press and hold this button down for three seconds, then release this button. The Instant GigaDrive™ will beep once to indicate that the default IP Address (192.168.1.77, with a Network Mask of 255.255.255.0) has been provided. This function will also clear the Instant GigaDrive's administrative passwords. Uplink Button This button toggles the Instant GigaDrive's Ethernet Connector between an Uplink setting and a standard setting. If the Instant GigaDrive™ is connected directly to a PC without a hub, then this button should be pressed in. If connecting to a hub or switch, this button should not be pressed in. If it is, press it once to release it. LAN Port Use this port to connect the Instant GigaDrive™ to your 10BaseT or 100BaseTX hub. 100 LED This LED will glow amber if the 10/100BaseTX connector is using 100BaseTX. 10 LED This LED will glow green if the 10/100BaseTX connector is using 10BaseT. The Instant GigaDrive's Front Panel The Instant GigaDrive's front panel, shown in Figure 2-2, displays the following LEDs. Drive LEDs Each disk drive has a green LED that flashes when the drive is active. The LED is located next to the lock on each of the drive trays. Ready Green. If this light shines a steady green, then the Instant GigaDrive™ is working properly. It blinks during Startup or Shutdown, and turns off after the shutdown is completed. It will also blink during a firmware upgrade. Error 4 Amber. If this light is flashing, then there is a hardware error. It will also flash during the power-on self test or a firmware upgrade. Once the self-test or upgrade are completed, it will turn off. Etherfast Network Attached Storage Figure 2-2 LAN Disk Disk Full Backup Green. Flashes when data is transmitted or received via the network. Green. Flashes when the Instant GigaDrive's hard drive is being accessed. It stays on during the self-test. Green. This LED will appear solid when the Instant Gigadrive™ has reached its maximum storage capacity. Green. When the Instant Gigadrive's backup utility is active, this LED will flash. 5