MSI 865PE NEO2-PLS User Guide - Page 29
Installing DDR Modules - socket
UPC - 816909004755
View all MSI 865PE NEO2-PLS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
MS-6728 ATX Mainboard channelDDR DIMMs. However, the same type and density memory modules are necessary while using dual-channel DDR, or instability may happen. Please refer to the following table for detailed dual-channel DDR. Other combination not listed below will function as single-channel DDR. DIMM1 (Ch A) 128MB~1GB 128MB~1GB DIMM2 (Ch A) 128MB~1GB 128MB~1GB DIMM3 (Ch B) 128MB~1GB 128MB~1GB DIMM4 (Ch B) 128MB~1GB 128MB~1GB System Density 256MB~2GB 256MB~2GB 512MB~4GB Installing DDR Modules 1. The DDR DIMM has only one notch on the center of module. The module will only fit in the right orientation. 2. Insert the DIMM memory module vertically into the DIMM slot. Then push it in until the golden finger on the memory module is deeply inserted in the socket. MSI Reminds You... You can barely see the golden finger if the module is properly inserted in the socket. 3. The plastic clip at each side of the DIMM slot will automatically close. Volt Notch 2-8