Magnavox W-10CR Window AC Owners Manual - Page 12
How To Install
View all Magnavox W-10CR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Fig.F Fig.G C: Align the hole in the top rail with those in the top of the unit as shown in Fig.F ,, D: Secure the top rail to the unit with the 3/8 Screws as shown in Fig.G. NOTE: For safety reasons, all four(4) screws MUST be securely fastened. HOW TO INSTALL NOTE: Top ,r,ail and Sliding Panels at each side are offset to provide the proper pitch to the rear of (5/16 ). This is necessary for proper condensed water utilization and drainage. If you are not using the Side Panels for any reason, this pitch to the rear must be maintained by other means. 1 Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels- be sure to use the proper panel for each side. When installed, the flange for securing the panel in place to the window sill will be facing into the room. Fig.1 " "section A. Hold the side Panel in one hand and gently pull back the center to free the open end. See Fig.1. Fig.2 Top Rail Bottom Rail Fig.3 B. Slide the free end " " section of the panel directly into the cabinet as shown in Fig. 2. Slide the panel down. Be sure to leave enough space to slip the top and bottom of the frame into the rails on the cabinet. C. Once the panel has been installed on the side of the cabinet, make sure it sits securely inside the frame channel by making slight adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet. Fig.3. D. Slide the panel all the way in and repeat on the other side. NOTE: If storm window blocks AC, see Fig. 10. 11