Makita HR2641X1 HR2631F Instruction Manual - Page 7

Hammering only 1. Hammering only 1 015342 For chipping, scaling or demolition operations, rotate the action mode changing knob to the symbol. Use a bull point, cold chisel, scaling chisel, etc. Torque limiter ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Side grip (auxiliary handle) 2 1. Protrusions 2. Grooves 1 CAUTION: • As soon as the torque limiter actuates, switch off the tool immediately. This will help prevent premature wear of the tool. • Bits such as hole saw, which tend to pinch or catch easily in the hole, are not appropriate for this tool. This is because they will cause the torque limiter to actuate too frequently. The torque limiter will actuate when a certain torque level is reached. The motor will disengage from the output shaft. When this happens, the bit will stop turning. Hook For Model HR2641 CAUTION: • Never hook the tool at high location or on potentially unstable surface. 1. Hook 015344 CAUTION: • Always use the side grip to ensure operating safety. Install the side grip so that the protrusions on the grip fit in between the grooves on the tool barrel. Then tighten the grip by turning clockwise at the desired position. It may be swung 360 ﾟ so as to be secured at any position. Bit grease Coat the bit shank head beforehand with a small amount of bit grease (about 0.5 - 1 g). This chuck lubrication assures smooth action and longer service life. Installing or removing the bit 1 2 1. Bit shank 2. Bit grease 1 015362 The hook is convenient for hanging the tool temporarily. To use the hook, simply lift up hook until it snaps into the open position. When not in use, always lower hook until it snaps into the closed position. 003150 Clean the bit shank and apply bit grease before installing the bit. 1. Bit 1 015254 7