Makita LS1040 Owners Manual - Page 22
CAUTION, Cutting repetitive lengths
View all Makita LS1040 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
3 1. Set plate 2. Holder 3. Screw Over 10mm (3/8") Over 460mm (18-1/8") 001790 90mm 25mm (3-9/16") (1") 1 1. Hole 90mm 107mm 107mm 90mm 1 (3-9/16") (4-7/32") (4-7/32") (3-9/16") 001846 1 2 CAUTION: • Use straight wood of even thickness as the wood facing. • Use screws to attach the wood facing to the guide fence. The screws should be installed so that the screw heads are below the surface of the wood facing. • When the wood facing is attached, do not turn the turn base with the handle lowered. The blade and/or the wood facing will be damaged. 8. Cutting repetitive lengths When cutting several pieces of stock to the same length, ranging from 240 mm (9 - 29/64") to 400 mm (15 - 3/4"), use of the set plate (optional accessory) will facilitate more efficient operation. Install the set plate on the holder (optional accessory) as shown in the figure. Align the cutting line on your workpiece with either the left or right side of the groove in the kerf board, and while holding the workpiece from moving, move the set plate flush against the end of the workpiece. Then secure the set plate with the screw. When the set plate is not used, loosen the screw and turn the set plate out of the way. NOTE: • Use of the holder-rod assembly (optional accessory) allows cutting repetitive lengths up to 2,200 mm (7.2 ft.) approximately. 22