Makita XNB01Z Makita XNB01 Instruction Manual - Page 4
Save These Instructions., Symbols, Important Safety, Instructions, For Battery Cartridge
![]() |
View all Makita XNB01Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
8. Keep hands and feet away from the ejection port area. 9. Follow instruction for lubricating and changing accessories. 10. Always remove the battery cartridge before loading the fasteners, adjustment, inspection, maintenance or after operation is over. 11. Make sure no one is nearby before operation. Never attempt to drive fasteners from both the inside and outside of wall at the same time. Fasteners may rip through and/or fly off, presenting a grave danger. 12. Watch your footing and maintain your balance with the tool. Make sure there is no one below when working in high locations. 13. Never use fastener driving tools marked with the symbol "Do not use on scaffoldings, ladders" for specific application for example: − when changing one driving location to another involves the use of scaffoldings, stairs, ladders, or ladder alike constructions, e.g. roof laths; − closing boxes or crates; − fitting transportation safety systems e.g. on vehicles and wagons. 14. Check walls, ceilings, floors, roofing and the like carefully to avoid possible electrical shock, gas leakage, explosions, etc. caused by stapling into live wires, conduits or gas pipes. 15. Use only fasteners specified in this manual. The use of any other fasteners may cause malfunction of the tool. 16. Do not tamper with the tool or attempt to use it for other than driving fasteners. 17. Do not operate the tool without fasteners. It shortens the service life of the tool. 18. Stop driving operations immediately if you notice something wrong or out of the ordinary with the tool. 19. Never drive fastener into any materials which may allow the fastener to puncture and fly through as a projectile. 20. Never actuate the switch trigger and safety lever at the same time until you are prepared to fastener workpieces. Allow the workpiece to depress the safety lever. Never defeat its purpose by securing the safety lever back or by depressing it by hand. 21. Never tamper with the safety lever. Check the safety lever frequently for proper operations. 22. Always remove fasteners from the tool when not in use. SAVE THESE INSTRUCTIONS. WARNING: DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to safety rules for the subject product. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. USD501-3 Symbols The followings show the symbols used for tool. ・ Read and understand tool labels and manual. ・ Operators and others in work area must wear safety glasses with side shields. ・ Keep fingers away from trigger when not driving fasteners to avoid accidental firing. ・ volts ・ direct current IMPORTANT SAFETY INSTRUCTIONS ENC007-8 FOR BATTERY CARTRIDGE 1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. 2. Do not disassemble battery cartridge. 3. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. 4. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. It may result in loss of your eyesight. 5. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. (2) Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. (3) Do not expose battery cartridge to water or rain. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. 4
![](/manual_guide/products/makita-xnb01z-makita-xnb01-instruction-manual-501e231/4.png)