Makita XNB01Z Makita XNB01 Instruction Manual - Page 7

Lighting up the lamp CAUTION: • Do not look in the light or see the source of light directly. 3 2 1. Lamp 2. Trigger 1 3. Driver guide (contact element) 014600 To turn on the lamp, pull the trigger or place the contact element against the workpiece. Release the trigger or contact element to turn it off. The lamp goes out 10 seconds after releasing the trigger or contact element from the workpiece. NOTE: • Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. • Even in the lamp lights up when the battery power residual gets small, the nailer may not fire nails. In this case, charge the battery cartridge. ASSEMBLY CAUTION: • Always make sure that your fingers are not placed on the trigger, and the battery cartridge and nails are removed before carrying out any work on the nailer. Loading or unloading the nails CAUTION: • Always make sure that your fingers are not placed on the trigger and the battery cartridge is removed before loading nails. • Do not abruptly slide the slide door of the nailer loaded with nails. Accidentally dropping nails especially when working in high places may cause personal injuries. • Load nails in the correct direction. Loading in wrong direction may cause premature wear and tear of the driver and damage of the other parts. • Do not use deformed connected nails. Use nails specified in this manual. Using nails other than those specified may cause nail jamming and breakage of the nailer. 1. Lock lever 1 2. Slide door 3. Driver guide 4. Magazine 3 4 2 014585 Press the lock lever and open the slide door of the magazine. 1. Nails 2. Slide door 3. Driver guide 3 2 1 014592 Set the nail strip so that the nail tips touch the bottom of the magazine slit and slide the nail strip toward the firing opening. Return the slide door to the original position until the lock lever locks it. To remove the nails, press the lock lever and slide the slide door. Take out nails from the magazine slit. Nose adapter CAUTION: • Always make sure that your fingers are not placed on the trigger, and the battery cartridge and nails are removed before installing the nose adapter. 1. Nose adapter 2. Protrusion 3. Center plate 3 4. Holder 4 1 2 014586 When firing nails on the material to be fastened with easily-marred surfaces, use the nose adapter. To install the nose adapter, place it over the center plate so that the protrusion inside the nose adapter fits to the slit in the driver guide cover. When not in use, store the nose adapter in the holder at the back end of the slide door to keep it from being lost. Total two nose adapters can be stored. 7