Makita XNB01Z Makita XNB01 Instruction Manual - Page 9
Maintenance
View all Makita XNB01Z manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
− For continuous nailing, pull the trigger first and then place the contact element against the workpiece. For the next actuation, you do not need to release the trigger. − For intermittent nailing, place the contact element against the workpiece and pull the trigger. For the next actuation, you need to reset the trigger first. Nails Nail NOTE: • This tool stops automatically under the following conditions: − If you release the trigger or contact element from workpiece before the tool finishes the operation completely. In this situation, pull the trigger again until the tool turns into standby. − When keep either pulling the trigger or placing the contact element about 5 seconds without another action. In this case, release the trigger or the contact element from workpiece to restart the operation. Anti dry fire mechanism This tool is equipped with an anti dry fire mechanism. It automatically stops driving nails when the remaining nails finish. In this case, load more nails to resume operation. Removing jammed nails WARNING: • Always make sure that the trigger is released, and the battery cartridge and nails are removed before removing jammed nails. 1. Hex bolt A 1 2. Hex bolt B 3. Hex bolt C 4. Driver guide cover 3 2 4 014591 Remove hex bolts they are securing the driver guide cover with the hex wrench. Take the jammed nails from the nail guide groove that has appeared. Secure the driver guide cover with hex bolts in the correct order. Tighten the hex bolt A, B and then C. NOTE: • After securing the driver guide cover, always make sure that the driver guide cover actuates properly. If it does not actuate properly, remove hex bolts and install the driver guide cover again. 004310 Handle nails and their box carefully. If the nails have been handled roughly, they may be out of shape or their connector breaks, causing poor nail feed. Humid Hot Nail 004311 Avoid storing nails in a very humid or hot place or place exposed to direct sunlight. MAINTENANCE CAUTION: • Always be sure that the tool is switched off and the battery cartridge and nails are removed before attempting to perform inspection or maintenance. • Never use gasoline, benzine, thinner, alcohol or the like. Discoloration, deformation or cracks may result. Cleaning of magazine When the pusher in the magazine does not move smoothly because of dust, sand, chips or other foreign matters, clean the magazine. 1. Hex bolt 1 014720 To remove the slide door, loosen the hex bolt on the magazine. 9