Makita XNB01Z Makita XNB01 Instruction Manual - Page 6

1. Battery indicator 1 014584 Overheat protection for tool When the tool is overheated, the tool stops automatically and the indicator blinks about 60 seconds. In this situation, let the tool cool before turning the tool on again. Overheat protection for battery When the battery is overheated, the tool stops automatically and the battery indicator lights up about 60 seconds. The tool does not start even if pulling the switch trigger. In this situation, let the battery cool before turning the tool on again. NOTE: The battery overheat protection works only with a battery cartridge with a star marking. 1 1. Star marking 012128 Overdischarge protection When the remaining battery capacity gets low, the indicator blinks. By further use, the tool stops and the indicator lights up about 60 seconds. In this situation, charge the battery cartridge. Using the trigger lock CAUTION: • When not in use or after operating the tool, always lock the trigger with the trigger lock. 1. Trigger lock 1 2. Press to Lock position 3. Press to Free position The tool has trigger lock to avoid accidents by an unintentional start. The trigger lock makes the trigger unmovable and let the tool cause no firing. To lock the trigger, set the lock button in the "LOCK" position. Before nailing, set the lock button in the " FREE" position. When not in use, always set it in the "LOCK" position and remove the battery cartridge from the tool. Nailing mode selection 1 2 1. Mode selecting button 2. Sequential mode 3. Continuous mode 3 014618 The tool has two different nailing modes. Select the desired nailing by the mode selecting button. For more detail, see the section "OPERATION". Intermittent nailing (sequential mode) This mode suits for driving a nail carefully and accurately. Continuous/ intermittent nailing (continuous mode) When the tool is set to this mode, you can choose either continuous or intermittent nailing by sequences of the trigger operation. Adjusting the nailing depth WARNING: • Always make sure that your fingers are not placed on the trigger, and the battery cartridge and nails are removed. A BB 1. Adjuster 1 014601 To get shallower depth, turn the adjuster to A direction as shown in the figure. To get deeper depth, turn the adjuster to B direction. Do not turn the adjuster too much, or the adjuster may get stuck. A2 3 014582 6