Makita XRT01TK XRT01 Instruction Manual - Page 11
Tying work
View all Makita XRT01TK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Before using the tool, make sure that the safety mechanism operates normally. If the tool operates without the safety mechanism operating, stop using the tool immediately. Ask your local Makita Service Center for repairs. Checking the trigger-lock The tool has the trigger-lock to prevent the tool from operating when you do not intend to use it. Lock the trigger and confirm that the switch trigger cannot be pulled. Checking the curl guide To prevent the operator from touching the binding or rotating parts of the tool tip by mistake, the tool will not operate even if the switch trigger is pulled while the curl guide is opened. When the operator releases their finger from the switch trigger and closes the curl guide, the tool can operate. CAUTION: If you open the curl guide and turn the power on to check the interlock, hold the curl guide as shown in the figure. Never bring your limbs or face close to the binding or rotating parts of the tool tip. Otherwise, you may be injured. 1 ► 1 . Curl guide Checkout for curl guide open/close detection Remove the tie wire, check the tool operation according to the following steps, and make sure that the tool does not start if the curl guide is open. 1. Turn the power off, and leave the curl guide open. 2. Turn the power on. If the tool will not operate and if the value "2" is shown on the display panel, the state of the tool is normal. Turn the power off, and close the curl guide. If the tool operates and if no error is shown on the display panel, the state of the tool is abnormal. Stop using the tool immediately, and ask your local Makita Service Center for repairs. Tying work CAUTION: Before inserting the battery cartridge, be sure to release your fingers from the switch trigger and lock the trigger. If you insert the battery cartridge while the switch trigger is being pulled, it may cause an accident if the wire tying process is accidentally carried out. CAUTION: When you turn the power on, never bring your limbs or face close to the binding or rotating parts of the tool tip. Otherwise, you may be injured. CAUTION: When the power is turned on, never touch the binding or rotating parts of the tool tip. Otherwise, you may be injured. 11 ENGLISH