Makita XRT01TK XRT01 Instruction Manual - Page 13
Continuous actuation mode, Cautions on working, Tying tips
View all Makita XRT01TK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Continuous actuation mode 1. Switch the tool mode from the single actuation mode to the continuous actuation mode using the mode switching button. 1 4. After tying, exercise care not to hook the arm on the rebars and pull the tool up. ► 1 . Mode switching button 2. Release the trigger lock. 3. While pulling the switch trigger, push the tool vertically against the rebars, and press the arm against the point where the rebars cross at a 45-degree angle. Press the contact plate firmly against the tying point. The wire will be tied. 45° 45° Cautions on working • If you move the arm from the tying position during the wire tying process, the wire will get stuck on the hook, which may lead to incorrect tying. • Keep pressing the tool against the rebars until the wire tying process is completed. • Do not move to the next tying point until the current wire tying process is completed. • The tool tip rotating part (hook) twists the wire during the wire tying process. Hold the grip firmly so that your body is not pulled by the tool. • Do not touch the wires during the wire tying process. • If you are repeating the wire tying processes in the single actuation mode, fully release your finger from the switch trigger. Then, continue to operate the switch trigger. • If you pull the switch trigger when there is no tie wire left, an error is displayed. Replace with a new tie wire and restart the tool. Tying tips • Tilt the tool at a 45° angle to the crossed rebars, and tie alternately as shown in the figure. 1 ► 1 . Contact plate 13 ENGLISH