Makita XRT01TK XRT01 Instruction Manual - Page 2

ENGLISH (Original instructions) SPECIFICATIONS Model: Tie wire (Optional accessory) Diameter of rebars that can be tied Approximate number of ties per reel Overall length Rated voltage Net weight XRT01 ø0.8 mm (21GA) From #3 x #3 to (#4 x 2) x (#4 x 2) From 10 mm x 10 mm to (13 mm x 2) x (13 mm x 2) Approximately 120 ties 304 mm (12") D.C. 14.4/18 V 2.3 - 2.6 kg (5.1 - 5.7 lbs) • Due to our continuing program of research and development, the specifications herein are subject to change without notice. • Specifications and battery cartridge may differ from country to country. • The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heaviest combination, according to EPTA-Procedure 01/2014, are shown in the table. Applicable battery cartridge and charger Battery cartridge D.C.14.4 V Model BL1430B D.C.18 V Model BL1815N / BL1820B / BL1830 / BL1830B / BL1840B / BL1850B / BL1860B Charger DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF • Some of the battery cartridges and chargers listed above may not be available depending on your region of residence. WARNING: Only use the battery cartridges and chargers listed above. Use of any other battery cartridges and chargers may cause injury and/or fire. Combination of rebars that can be tied Combination of 2 rebars #3 (10 mm) #3 (10 mm) #4 (13 mm) #5 (16 mm) #4 (13 mm) #5 (16 mm) Combination of 3 rebars #3 (10 mm) #4 (13 mm) #5 (16 mm) #3 x #3 (10 mm x 10 mm) #4 x #4 (13 mm x 13 mm) - Combination of 4 rebars #3 x #3 (10 mm x 10 mm) #4 x #4 (13 mm x 13 mm) #3 x #3 (10 mm x 10 mm) #4 x #4 (13 mm x 13 mm) NOTICE: If there is a gap between rebars or if the tool is used at an incorrect orientation, the rebars may not be able to be tied. 2 ENGLISH