Marantz RC2000MKII User Guide - Page 10

¼ You have up to four characters available for each direct function button name. To change the page D4 D8 DSS MD TV LD DVD VCR Press the page button. 8. After completing all re-writing of any of the names, press the OK button within the cursor keys !6. To change the function DSS MD TV LD DVD VCR TUNER CD TAPE AUX AMP Press any of these buttons. 9. If, during re-naming, a button has not been pressed for 1 minute, the RC2000 Mk w will revert to the prior operating mode automatically. 10. If re-writing of all of the desired direct mode functions has been completed, use the paper clip tip to press the operation mode button q, and select the "USE" mode. Now, all of the re-written names are available for use. POWER SOURCE ON ON/OFF OFF CLONE MACRO MODE MACRO LEARNING REMOTE CONTROL RC2000MK MACRO Press the MODE button to switch to USE. Note: The status and direct mode names of each page that are not rewritten remain without being erased. How to clear (erase) the memorized codes (and any re-written names): The RC2000 Mk w has a high capacity RAM, which ordinarily will allow the learning of several hundred remote codes (and their associated new names, if desired). However, due to the fact that some remote codes occupy more memory space than others, it is possible that the available RAM fills up completely, and the "FULL" indicator appears in the LCD window. In this case, it will not be possible to learn any new remote codes without first deleting some or all of the previously learned remote codes and/or re-written names. There are 4 ways to erase learned remote codes from memory: 19 ¼ Erasing by button(s) ¼ Erasing by function(s) ¼ Erasing by direct buttons (Pages) ¼ Erasing all memory contents (complete erasure) ¼ Note: The factory-programmed RC-5 codes are not stored in RAM, and are therefore not erasable. 1. For any of these memory erasure options, you must first set the RC2000 Mk w to LEARN mode. POWER SOURCE ON ON/OFF OFF CLONE MACRO MODE Press the MODE button to switch to LEARN. 2. Erasing the commands assigned to pages 1-4 of each direct button: Press and hold the "CLEAR" botton and press ̇ or ̈ button twice. You will see "DIR CLR" indicated in the LCD window. At that point, if you press "OK" in the cursor keys, you will erase all four pages in that particular direct function. After clearing, the RC2000 Mk w will restore any factory programmed codes. If you do not wish to clear the pages, press any other key other than the "OK" button. 3. Erasing the memory assigned to a particular button: First check the current function. (In this example, let us assume that it is LD.) Press and hold the "CLEAR" button !4 and press the button that you wish to erase 2 times. The code previously learned by that button will be erased, and will then be either empty, or the original factory provided RC-5 codes will re-appear in its place. TUNER CD TAPE AUX AMP CH VOL 123 456 OK 789 OSD GUIDE MUTE M0C While holding the CLEAR button depressed, press PLAY twice. The LD PLAY code is cleared and the original RC-5 code is recalled. 20