Marantz SR7200 User Guide - Page 26

O CONTROL indicator Indicates when the < • s (CURSOR/TRANSPORT CONTROL switching)El is In a transport control mode such as PLAY, STOP, etc. • If the LCD flickers when a button is pressed in order to transmit a command or when in the LEARN mode, the transmission or learning is not possible. In such a case, please replace the batteries. • This remote controller uses non-volatile memory, so that learned codes and macros will be preserved even if the batteries are removed. BASIC OPERATION USE MODE The remote controller will normally be used in the USE mode. It comes preset with codes commonly used to control 11 types of components manufactured by Marantz and Philips, including OSS, DVD, TV, LD, VCR, AUX, TUNER, CD, TAPE, CD-R/MD, and AMP, as well as many others that utilize the RC-5 remote control language. 1. Press once one of the Function buttons 0 to change to another component's commands, such as DVD button. c'CI741-11) 2. DVD will be displayed on the LCD and the function codes will be set to operate the DVD player, and if you double clicked the DVD function button, the preamplifier or receiver's Input will be changed as well. 3. Now you can operate the DVD player. When a button Is pressed, the ;•-,7' symbol indicates that a remote code is being transmitted. is not displayed if a button for which no code has been set is pressed. 4. The Jog Dial El is used to select any one of up to 10 direct operations that can be performed for each of the 11 functions (DVD, TV, AMP, etc.). Rotate the Jog Dial 1] to select one of these commands. The number of the current page Is indicated by II- 0. Page numbers cycle up or down, for example --> -> etc. ore --> etc. depending on which way the Jog Dial Is rotated. The last page position for any given command function is retained in the memory even if the remote controller is switched to the command function for another component. (Last Memory) If it is left for approximately 1 minute without pressing any buttons, all items on the LCD will go off except the function indicator. Even if the display goes off, the remote controller will hold the page position and other data. The display may be activated again by pressing any button. LEARN MODE The remote controller is capable of learning and memorizing the remote control codes used by almost any other remote controller you may already own. • If no commands have been programmed for a particular function button, the remote controller will transmit whatever codes have been factory preset. • The following example shows how to program your remote controller and how to use the codes for a DVD player. • The remote controller Infrared receiver is located at the top of the remote controller. 1. Use a ballpoint pen or other sharp paint to press the MODE button 0 until the LEARN indicator is displayed. Each time you press this button, the mode will cycle through LEARN NAME -4 USE. Stop when the LEARN Indicator starts to blink. 2. Place the DVD's remote controller so that its infrared signal transmitter is facing the infrared signal receiver on the Marantz remote controller at a distance of about 5 centimeters (2 inches). OK NO GOOD Top View O0V,Dram,,o Top View RC7200SR 8C72°()S8 ilgr iarlige A.ce U'm00o0o 1c0ro0o0n0 1e.,''F.,,F.Cµ':, °pain ",-ga 00000 00000 ,, li' Side View DUD remote control u - 1 5 CM Side View RCNIXISR RaXOSR yL Dcrit4trifgt 19