Maytag M8TXEGFBW Use & Care Guide - Page 13

13

Reversibility Kit Instructions

(contour door models only)

If your model came with a Reversibility kit or you purchased a kit

for your contour door refrigerator, please use the Brand Badge

Placement template and the following instructions to install the

Brand Badge on the opposite side of the freezer door.

Parts Included:

Brand badge removal tool

Brand badge template (on last page of User Instructions)

Hole cover decal (color coordinated to exterior)

Tools Needed:

Scissors

Masking tape

Freezer Door

1.

Using the removal tool (provided), remove the brand badge

from the freezer door by lifting up the right-hand side and

peeling the badge away from the door from right to left.

NOTE:

To avoid scratching the door, do not use a sharp or

metallic object to pry the brand badge from the door.

2.

Rub a small amount of liquid dish soap over any adhesive

residue with your fingers. Rinse the door with warm water and

dry with a soft cloth.

3.

Cut the template along the dotted lines that match the shape

of the brand badge.

4.

Align the edges of the template with the side and top of the

freezer door and tape the template to the door.

NOTE:

When the template is correctly aligned, the hole in the

door, where the handle was, will be within the cutout of the

template, as shown.

5.

Using the cutout as a guide, press the brand badge onto the

freezer door making sure that the hole is completely covered.

6.

Slowly remove the template.

Adjust the Doors

IMPORTANT:

To comply with American Disabilities Act (ADA)

guidelines, fully retract the rollers into the cabinet to lower the

refrigerator.

Door Closing

Your refrigerator has two front adjustable rollers – one on the right

and one on the left. If your refrigerator seems unsteady or you

want the doors to close easier,

adjust the refrigerator's tilt using

the following instructions:

1.

Remove the base grille. See the Base Grille graphic in

“Refrigerator Doors.” The two leveling screws are part of the

front roller assemblies, which are at the base of the

refrigerator on either side.

2.

Use a socket driver to adjust the leveling screws. Turn the

leveling screw to the right to raise that side of the refrigerator

or turn the leveling screw to the left to lower that side. It may

take several turns of the leveling screws to adjust the tilt of

the refrigerator.

NOTE:

Having someone push against the top of the

refrigerator takes some weight off the leveling screws and

rollers which makes it easier to adjust.

3.

Open both doors again to make sure they close as easily as

you like and that they stay closed. If not, tilt the refrigerator

slightly more to the rear by turning both leveling screws to the

right. It may take several more turns.

NOTES:

■

To keep the refrigerator level, you should turn both

leveling screws the same amount.

■

On models with the leveling/roller assembly, after

adjusting the refrigerator to the desired tilt, turn the

leveling leg until it is firmly against the floor as shown.

On some models

4.

Replace the base grille.

A. Bottom hinge

B. Screws

C. Leveling/roller assembly

A

B

C

Maytag M8TXEGFBW Use & Care Guide - Page 13

Reversibility Kit Instructions, Adjust the Doors

Page 13 highlights