Maytag M8TXEGFBW Use & Care Guide - Page 15
Refrigerator Use
View all Maytag M8TXEGFBW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Installing the Produce Preserver CAUTION: IRRITANT MAY IRRITATE EYES AND SKIN. DANGEROUS FUMES FORM WHEN MIXED WITH OTHER PRODUCTS. Do not mix with cleaning products containing ammonia, bleach or acids. Do not get in eyes, on skin or clothing. Do not breathe dust. Keep out of reach of children. FIRST AID TREATMENT: Contains potassium permanganate. If swallowed, call a Poison Control Center or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for 15 minutes. If on skin, rinse with water. The produce preserver pouches should be installed in the housing, located on the wall of one of the crisper drawers. 1. Remove the FreshFlow™ Produce Preserver pouches from the packaging. 2. Lift up on the housing to remove it from the mounting tab. 3. Open the housing by pulling up and out on the back of the top of the housing. 4. Place both pouches inside the housing, then snap the housing back together. 5. Place the housing back on the mounting tab. Installing the Status Indicator The produce preserver comes with a status indicator, which should be activated and installed at the same time the pouches are installed. CAUTION IRRITANT Read cautions on back. ATTENTION IRRITANT Lisez des prudences sur le revers. 4. Place the indicator in the top of the housing, facing outward. 5. Slide the cap closed, and check that the indicator is visible through the rectangular hole in the cap. NOTE: The cap will not easily close if the indicator's bubble has not been popped. Replacing the Produce Preserver The disposable pouches should be replaced every 6 months, when the status indicator has completely changed from white to red. To order replacements, contact us. See "Accessories" for information on ordering. 1. Remove the used pouches from the produce preserver housing. 2. Remove the used status indicator. 3. Install the replacement pouches and status indicator using the instructions in the previous sections. REFRIGERATOR USE Using the Controls The temperature controls are located at the top front of the refrigerator or freezer compartments. Temperature Controls For your convenience, the temperature controls are preset at the factory. When you first install your refrigerator, make sure the controls are still set to the recommended setting as shown. Style 1 Recommended Setting Style 2 Recommended Setting REPLACE MONTHS Style 3 Recommended Setting "3 Snowflakes" 1. Place the indicator face-down on a firm, flat surface. 2. Apply pressure to the bubble on the back of the indicator until the bubble pops, to activate the indicator. 3. Slide open the cap on the top of the produce preserver housing. 15