Maytag MHWZ600TE Use and Care Guide - Page 26

Leaking • Was the door opened during"Add a garment"? Water can drip off the inside of the door, when the door is opened after the start of a cycle. • Is HE detergent being used? [he non-High Efficiency detergents can cause oversudsing which can leak from the rear of the washer. • Are the fill hoses tight? • Are the fill hose gaskets properly seated? Check both ends of each hose. See "Connect the Inlet Hoses." • Is the drain hose properly installed? [he drain hose should be secured to the drainpipe or laundry tub. See "Secure the Drain Hose." Is the sink or drain clogged? Sink and drainpipe must be able to carry away 17 gal. (64 L) of water per minute. If clogged or slow, water can back up out of drainpipe or sink. Check household plumbing (laundry tubs, faucets, drainpipe, water pipes) for leaks. Dispenser operation • Did you follow the manufacturer's directions when adding detergent and fabric softener to the dispensers? Measure detergent and fabric softener. Slowly pour into the dispensers. Wipe up all spills. Dilute fabric softener in the fabric softener dispenser. • Did you put powdered or liquid color-safe bleach into the liquid chlorine bleach dispenser (on some models)? Add powdered or liquid color-safe bleach to the Main Wash compartment. Do not use the chlorine bleach dispenser for color-safe bleach. • Is the fabric softener dispenser clogged? Clean the fabric softener dispenser. See "Washer Care" for details. • Are the laundry products in the correct dispenser compartment? Add the correct amounts of detergent, fabric softener or liquid chlorine bleach to the correct compartments. Add powdered or liquid color-safe bleach to the Main Wash compartment. • Is there water in the dispenser at the end of the cycle? A small amount of water will remain in the dispenser compartment. This is normal. Washer odor • See "Cleaning Your Washer." • Are you using HE detergent? Use of non-HE detergent can cause a film residue which can result in odor. • Did you leave the door open after use? This washer has a tight seal to avoid water leaks, lb avoid odors leave the door open to allow the washer to dry between uses. Door won't unlock • Did all of the water drain out of the washer during the spin? Select RINSE & SPIN, and then select EXTRA RINSE (to turn off the rinse option) to remove any water remaining in the washer. The washer door will unlock at the end of the drain. • Is the door locked and is the "Add a garment" light on? Press PAUSE/CANCEl once. The door will unlock. Washer won't run, fill, rinse or tumble; washer stops Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Is the power cord plugged into a grounded 3 prong outlet? Plug power cord into a grounded 3 prong outlet. Are you using an extension cord? Do not use an extension cord. Has a household fuse blown, or has a circuit breaker tripped? Replace the fuse, or reset the circuit breaker If the problem continues, Are both the hot and cold water faucets turned on? [urn on the water. call an electrician, Is the water inlet hose kinked? Straighten the hoses. 26