Miele F 1901 Vi Operating and Installation manual - Page 61
Securing an alternative anti-tip, device, Determine the number of screws
![]() |
View all Miele F 1901 Vi manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Installing the appliance Securing an alternative anti-tip device If the anti-tip brackets cannot be attached securely, an alternative anti-tip device can be used. Ensure that there is no "give" between the appliance and the anti-tip device. If possible, always screw the wooden beam to existing studs. - The beam must cover the appliance by at least 2" (50.8 mm). ^ Mark the installation height (lower edge of the beam) on the rear wall of the niche. ^ Select screws according to the thickness of the wooden beam. Example: 3 ½" screw for 2x4 beam. Determine the number of screws based on the niche width, to ensure that the beam will be attached securely. ^ Locate wall studs near the rear wall of the cavity and mark drill holes in the beam. ^ Pre-drill the wooden beam. ^ Attach the wooden beam to the rear wall of the niche. Now prepare the water connection from the appliance to the main supply line (see "Plumbing"). - Cut a wooden beam (cross section min. 3" x 4" [75 mm x 100 mm]) to the required length. - The length is equal to the width of the installation niche. - If the installation niche is deeper than the appliance, select a beam with a larger cross section, or attach two beams. 61
![](/manual_guide/products/miele-f-1911-vi-operating-installation-manual-a49b0d9/61.png)