Motorola HMN9013 User Manual - Page 72

Restore Channels/Talkgroups to the Scan List Power off the radio then turn it on. - OR - Press the preprogrammed Scan button to stop the scan. The deleted nuisance channels/talkgroups are restored to the scan list. - OR - Select a channel/talkgroup that has not been preprogrammed for scan by your dealer/programmer. Once you return to the original channel/ talkgroup, the deleted nuisance channels/talkgroups are restored to the scan list. Send a Selective Call 1. From the Selective Call menu, select or enter desired radio ID number. 2. Press PTT button to send the call. 3. Press and hold the PTT button to speak; release to listen. Receive a Selective Call 1. When a Selective Call is received, the radio displays F and the name or ID of the calling radio; the LED flashes yellow and two tones are heard. 2. Press PTT button to acknowledge the call. 3. Press and hold the PTT button to speak; release to listen. LED Indicators LED State/Color Indication Radio Call Red Transmitting Flashing Red Receiving Flashing Red Channel/Talkgroup Busy Scan Flashing Green Scanning for activity Call Alert Flashing Yellow Indicates receiving a Call Alert Yellow Indicates sending a Call Alert Selective Call Flashing Yellow Indicates receiving a Selective Call Yellow Indicates sending a Selective Call Sticky Monitor/Open Squelch Yellow While monitoring Audio Indicators for Programmable Buttons Programmable Buttons Positive Indicator Tone Scan Start Power Level High Squelch Tight Repeater/Talkaround Does not use repeater VOX Enabled Silent Monitor/Open Squelch - Revert Memory Channel (1&2) - Store Memory Channel (1&2) - Home Revert AutoKey (1&2) - Menu Mode J - Radio Call - Scan List Edit - Speed Dial - Phone Mode - Option Board Enabled Escalert Enabled Negative Indicator Tone Stop Low Normal Uses repeater Disabled Enabled Enabled Stored Enabled Accessed Enabled Enabled Enabled Enabled Disabled Disabled You can check battery charge status if your dealer has preprogrammed one of the programmable buttons. Hold down the preprogrammed Bat- tery Indicator button. The charge status is shown on the display. Battery Level Full Good Fair Low Display Very Low